LINE

• click the icon
• specify first point (left-click)
• specify second point
• Right-click to 'back' or press 'Esc' to exit.

2 points with more detail (tips for drawing a specific length of a line; type the BOLD one into command-line).

• specify the First point (left-click).
• @50<0 for straight line.
• @50,50 for Square or @50,30 for Rectangle.
• @60<120 for 60mm line at 120 degrees. (try {-} (minus) symbol before 'degree' and see what happen!!)

• click the icon
• enter angle (see 'tool option')
• enter length
• specify start, middle, or end snap point
  • specify position
• Right-click to 'back' or press 'Esc' to exit

• click the icon
• enter length
• specify start, middle, or end snap point
  • specify position
• Right-click to 'back' or press 'Esc' to exit

• click the icon
• enter length
• specify start, middle, or end snap point
  • specify position
• Right-click to 'back' or press 'Esc' to exit

• click the icon
• specify first corner
• specify second corner
• Right-click to 'back' or press 'Esc' to exit

• click the icon
• select entity
• specify through point (click at specific point or anywhere to repeat the process)
• Right-click to 'back' or press 'Esc' to exit

• click the icon
• enter the distance and number of copies required OR
  • select entities and repeat it as required
• Right-click to 'back' or press 'Esc' to exit

• click the icon
• enter length and number (from tool option)
  • select first line
  • select second line
• Right-click to 'back' or press 'Esc' to exit

• click the icon
• specify point
• select circle, arc or ellipse
• Right-click to 'back' or press 'Esc' to exit

• click the
• select first circle or ellipse
• select second circle or ellipse
• Right-click to 'back' or press 'Esc' to exit

• click the icon
• select a line
• select circle, arc or ellipse
• Right-click to 'back' or press 'Esc' to exit

• click the icon
• select line
• select circle, arc or ellipse
• Right-click to 'back' or press 'Esc' to exit

• click the icon
• enter angle and length
  • select base entity
  • select position
• Right-click to 'back' or press 'Esc' to exit

• click the icon
  • enter number of sides as required
    • specify center
    • specify corner
• click the icon
  • enter number of sides as required
    • specify center
    • specify tangent
• click the icon
  • enter number of sides as required
    • specify first corner
    • specify second corner
• Right-click to 'back' or press 'Esc' to exit