This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
usage:howto [2020/03/30 21:59] – How to add radius circle tangent to two lines flywire | usage:howto [2020/06/26 04:08] – Markup code flywire | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== How to ====== | + | [[usage: |
This section describes how to perform some tasks in addition to //User Manual// and //User Guides//. | This section describes how to perform some tasks in addition to //User Manual// and //User Guides//. | ||
The content is the following: | The content is the following: | ||
- | | + | |
- | | + | |
- | | + | |
+ | * [[usage: | ||
+ | |||
+ | ---- | ||
===== How to copy entities from drawing A to drawing B? ===== | ===== How to copy entities from drawing A to drawing B? ===== | ||
Line 24: | Line 28: | ||
Let's say, we want to create a special part as shown below. Note that there are 2 layers, one for the part (yellow) and one for its axis (red). {{usage: | Let's say, we want to create a special part as shown below. Note that there are 2 layers, one for the part (yellow) and one for its axis (red). {{usage: | ||
- | |||
==== Step 1: create a block ==== | ==== Step 1: create a block ==== | ||
Line 54: | Line 57: | ||
- Optionally, you can modify the block: look at the [[https:// | - Optionally, you can modify the block: look at the [[https:// | ||
- | Note that other folders are also visible: these are coming by **standard** with the installation of LibreCAD. Your library will be **added** to the standard library. This way, **your library is not deleted when uninstalling | + | Note that other folders are also visible: these are coming by **standard** with the installation of LibreCAD. Your library will be **added** to the standard library. This way, **your library is not deleted when uninstalling |
===== How to add radius circle tangent to two lines ? ===== | ===== How to add radius circle tangent to two lines ? ===== | ||
Line 66: | Line 69: | ||
{{usage: | {{usage: | ||
+ | |||
+ | ===== How to convert from mm to inches ? ===== | ||
+ | |||
+ | Let's assume General Scale is set to 1. | ||
+ | This is for an intended print scale of 1: | ||
+ | |||
+ | Then to scale from mm to inches: | ||
+ | |||
+ | - Select all, by command (Tools - Select - Select All), or by pulling up a window around it. | ||
+ | - Scale (Tools - Modify - Scale) | ||
+ | - Specify reference point, normally best 0,0. Enter. | ||
+ | - In the Scaling Options:\\ {{: | ||
+ | |||
+ | To adapt the Drawing Preferences to inches: | ||
+ | |||
+ | - Set Main Units:\\ {{: | ||
+ | - Adapt Dimensions. You could do it with General Scale 1/25.4, but better let it at 1 for possible later print scaling and change the size values individually. You can later use these settings for all your inches drawings.\\ {{: | ||
+ | |||
+ |