User Tools

Site Tools


Sidebar

Introduction

* Home

Documentation & help

LibreCAD Community

Help on DokuWiki

Temporary shorcuts

usage:line

This is an old revision of the document!


LINE

Tool: LINE

LINE: 2 Points

  • click the icon.
  • specify first point (left-click).
  • specify second point
  • Right-click to 'back' or press 'Esc' to exit.

2 points with more detail (tips for drawing a specific length of a line; type the BOLD one into command-line).

  • specify the First point (left-click).
  • @50<0 for straight line.
  • @50,50 for Square or @50,30 for Rectangle.
  • @60<120 for 60mm line at 120 degrees. (try {-} (minus) symbol before 'degree' and see what happen!!)

LINE: Angle

  • click the icon
  • enter angle (see 'tool option').
  • enter length.
  • specify start, middle, or end snap point.

LINE: Horizontal

LINE: Vertical

LINE: Rectangle

LINE: Parallel through point

LINE: Parallel

LINE: Bisector

LINE: Tangent (P,C)

LINE: Tangent (C,C)

LINE: Tangent Orthogonal

LINE: Orthogonal

LINE: Relative Angle

LINE: Polygon [(Cen,Cor), (Cen,Tan), (Cor,Cor)]

usage/line.1592458697.txt.gz · Last modified: 2020/06/18 05:38 by dushyantvyasg007